Failsafe Mode
– Set your computer’s IP to 192.168.1.2, subnet 255.255.255.0
– Connect the TL-MR3020 to your computer via ethernet
– Power on the TL-MR3020
– When the WPS Button starts to blink , push it until it blinks faster
– The device is now in Failsafe-Mode
– You may access it by using telnet 192.168.1.1
In failsafe mode
The root file system in failsafe mode is the only the SquashFS partition. The JFFS2 is not present. To mount JFFS2 in read-write mode run this command:
– mount_root
and then repair your system:
– In case you forgot your password, you need to set a new one. Type:
passwd
– In case you filled up the entire JFFS2 by installing too big/too many packages, clean the entire JFFS2 partition. All settings will be reset and all installed packages are removed. (OpenWrt equivalent of a factory reset)
firstboot
or (this will reboot the device as part of the process)
mtd -r erase rootfs_data
or
rm -r /overlay/*
If you are done with failsafe mode use
– reboot -f
Thanks a lot for this very informative text. It helped a lot.
Thanks it works!!